Rent the largest dehumidifier available.
What happens if your carpet gets wet.
Don t waste your time trying to dry out the carpet with a wet dry shop vacuum it simply doesn t have enough power.
Then it s time to extract the water from the carpet.
Clean and dry everything.
At this point the two things the glue was holding together begin to separate and allows an area for mold to begin growing.
The most important part is first stopping water from flowing into the problem area.
Take off the waste bin.
The sun s uv rays will also kill some of the.
Set it to dry and move it around the wet carpeting.
Go over the damp carpeting multiple times in slow straight lines.
In unfortunate instances you may also experience flooding a plumbing malfunction or an issue with a diy carpet cleaning machine that could create a soaking wet carpet.
If the carpet is an area rug then the carpet can be placed outdoors in the direct sunlight during the warm hot months of the year to dry the carpet.
When carpet gets wet and is left wet it can cause problems like delamination that happens when there is excessive moisture which weakens the glue.
Gather up all the towels you can spare and begin soaking up the excess moisture.
Wet carpet should be dealt with quickly to keep your carpet intact and to avoid problems with mold and mildew.
For those with children and pets small spills can happen often.
Fans bleach and cleaners.
Make sure your hands are dry and plug in the wet dry vacuum.
If your roomba happens to hit a wet spot on your floor this is what you should do.
Wet vacs are the perfect tool for.
The sooner you start cleaning up after water damage the sooner you can stop mold from growing under your carpet.
It is best to clear out the entire room if the carpet is completely flooded.
Remove the brushes and filter.
If you can get the furniture to another room or a garage try that method.
Pull the carpets depending on how wet things are you may need to pull the carpets.
If the carpet gets wet again or the carpet is exposed to elevated levels of moisture humidity then mold growth and related odors will likely recur.
Spread towels over the wet carpet.
Vacuum the carpets thoroughly and then hang them somewhere to dry.
Be more careful next time.
Remove the battery pack.
If it s only partially flooded move everything over to the dry side.
Follow these steps for drying your carpet properly and preventing the spread of moisture and mildew.
The easiest way to get the moisture or water out of your carpet is by removing it with a wet vacuum.
Red cross officials say many homeowners can get rid of the mold just fine after a flood but it will require a bit of elbow grease.
We highly suggest you do this to prevent mold and mildew pulling your carpet out isn t hard and will help you find any areas where water is pooling.