Where To Start Shingling A Hip Roof

The next one goes on the low side.

Where to start shingling a hip roof.

Working on the base of the edges of your hip roof by making use of 2 stacked shingles. This project guide is a combination of those two articles and it covers replacing the existing roof decking installing underlayment and ice dam protection laying the first row laying shingles in the field flashing ridge shingles and vents and more. Install cedar shingles with two 5 penny. Unroll the felt so that the lines are facing upward.

As you place each new row make sure the center of the next shingle up overlaps the previous row by 2 3 of the total length. Roofing felt comes in rolls that feature pre marked lines 2 to 3 inches from the top and bottom edges. After that line the shingle up with the roof and drive two nails through the top corners and one in the center to fasten it in place. Step 2 line up the first shingle with the bottom of the entire shingle lined up with the bottom edge of the roof.

You will also want to place them on top and do your best to center them on a seam between two on the previous row. Prepare the shingles on the surface of the roof. Then trim the sides using a utility knife to match the angles. You can position them starting at the bottom or at the edges.

Start nailing the shingles on the topmost corners. Install the flashing on the ridges and tin strips along the edges of the hip roof to provide additional protection against water damage. The starting shingles for each row will typically be halved at the ridge of the hip roof as you ascend. You want to lay the shingles from the bottom to the top of the valley.

Weave and cut the valley on the highest side of the roof. Start by overlapping a starter from both sides of the valley at the bottom. Now use a single cap at every spot as you go up the ridge. The lower edges of the shingles align with the lower edge of the roof.

Start at one edge of the roof and install the first row of cedar or asphalt shingles. A couple of weeks ago we published a two part series showing how a local roofing contractor shingled a roof with architectural shingles. Step 1 start at the bottom of one side of the roof at the right or left edge. Using a utility knife trim the right or left sides of your shingle depending on the end you started at so that it fits the angle of the roof.